Introduction

I have been a long time B body lover and just found this forum and thought I would throw up some pics of my junk.
It is a '78 with a small block and some nitrous.

Nice run, great to see a smoking fast B Body !

I see a lot of posts on what seats fit and interior mods, so here is my interior. Sorry there is still a lot of junk, bounce sheets and the cover jammed in there. The front seats are mounted to the 1 x 1 frame that I made.

Nice job clean and to the point!

I like your buckets combination.

Let alone how it runs down the track.

What all is done to the car. Gears, Transmission etc.

Thanks for the vid.

It is a 350 that is bored over .030”. It has an Eagle crank and rods, SRP pistons, Comp solid flat lifters and cam(260/260@.050”,.555 lift), ported and polished Edelbrock RPM heads, Edelbrock single plane intake, 750 Holley HP carb, 3800 stall, TH350, 4.56:1 gears and Progressive nitrous controller(usually 100HP but I have tried 250HP). The engine is 17 years old now I have considered new parts and new technology but it works too good to take apart.

That's a lot of power and a great ET. for a B-Body.

Its well set up. Are you running a 3 speed auto.?

I like what you did with the dash, Tach. and gauges.  

I have looked at mine to customize as well.

Thanks.

It is a three speed turbo 350.